Standards |
‧IEEE 802.3 10Base-T Ethernet
‧IEEE 802.3u 100Base-TX/ FX
‧IEEE802.3ab 1000Base-T
‧IEEE802.3z Gigabit fiber
‧IEEE802.3x Flow Control and Back Pressure
‧IEEE802.3ad Port trunk with LACP
‧IEEE802.3af Power over Ethernet
‧IEEE802.1d Spanning Tree/ IEEE802.1w Rapid Spanning Tree
‧IEEE802.1p Class of Service
‧IEEE802.1Q VLAN Tag
‧IEEE 802.1x User Authentication (Radius)?
‧IEEE802.1ab LLDP |
Switch Architecture |
‧Back-plane (Switching Fabric): 5.6Gbps
‧Packet throughput ability(Full-Duplex): 8.3Mpps @64bytes |
Transfer Rate |
‧14,880pps for Ethernet port
‧148,800pps for Fast Ethernet port
‧1,488,000pps for Gigabit Fiber Ethernet port |
Memory Buffer |
‧1Mbits built-in |
Mac Address |
‧8K MAC address table |
Flash ROM |
‧4Mbytes |
DRAM |
‧32Mbytes |
Interface |
‧10/100TX: 8* RJ-45
‧10/100/1000T/SFP Combo: 2* RJ-45 + 2* 100/1000 SFP sockets
‧RS-232 connector: RJ-45 type |
PoE pin assignment |
‧RJ-45 port 1~8
support IEEE 802.3af End-Span, Alternative A mode
‧Per port provides 15.4W ability
‧ Positive (VCC+): RJ-45 pin 1, 2,
Negative (VCC-): RJ-45 pin 3, 6 |
Protocol |
‧CSMA/CD |
LED |
‧Per unit: Power (Green), Power 1 (Green), Power 2 (Green),
Fault (Red), Master (Green), FWD (Green)
‧8 port 10/100: Link/Activity (Green), Full duplex/Collision (Yellow) ?
‧SFP port: LNK/ACT(Green), 1000T: LNK/ACT(Green), 1000M(Green) |
SNMP |
‧SNMP v1 v2c, v3/ Web/Telnet/CLI
‧RFC 1215 Trap, RFC1213 MIBII, RFC 1157 SNMP MIB, RFC 1493 Bridge MIB, RFC 2674 VLAN MIB, RFC 1643 , RFC 1757, RSTP MIB, Private MIB, LLDP MIB |
VLAN |
‧Port Based VLAN 256 entries
‧IEEE 802.1Q Tag VLAN (256 entries)/ VLAN ID (Up to 4K, VLAN ID can be assigned
from 1 to 4094.)
‧GVRP (256 Groups) |
Port Trunk with LACP |
‧LACP Port Trunk: 4 Trunk groups/Maximum 4 trunk members |
LLDP |
‧Support LLDP to allow switch to advise its identification and capability on the LAN |
Spanning Tree |
‧Support IEEE802.1d Spanning Tree and IEEE802.1w Rapid Spanning Tree |
X-Ring |
‧Support X-ring, Dual Homing and Couple Ring Topology
‧Provide redundant backup feature and the recovery time below 20ms |
QoS |
‧The quality of service determined by port, Tag and IPv4 Type of service,
IPv4 Different Service |
CoS |
‧Support IEEE802.1p class of service, per port provides 4 priority queues |
Port Security |
‧Support 50 entries of MAC address for static MAC and another 50 for MAC filter |
Port Mirror |
‧Support 3 mirroring types: “RX, TX and Both packet” |
IGMP |
‧Support IGMP snooping v1,v2
‧256 multicast groups and IGMP query
‧Support 50 entries for multicast filter |
IP Security |
‧Support 10 IP addresses that have permission to access the switch management
and to prevent unauthorized intruder |
Login Security |
‧Support IEEE802.1X Authentication/RADIUS |
Bandwidth Control |
‧Support ingress packet filter and egress packet limit
‧The egress rate control supports all of packet type and the limit rates are 100K~102400Kbps(10/100), 100K~256000Kbps(1000)
‧Ingress filter packet type combination rules are Broadcast/Multicast/Unknown Unicast packet, Broadcast/Multicast packet, Broadcast packet only and all of packet. The packet filter rate can be set from 100K~102400Kbps(10/100), 100K~256000Kbps(1000) |
Flow Control |
‧Support Flow Control for Full-duplex and Back Pressure for Half-duplex |
System Log |
‧Support System log record and remote system log server |
SMTP |
‧Support SMTP Server and 6 e-mail accounts for receiving event alert |
Relay Alarm |
‧Provides one relay output for port breakdown, power fail and alarm
‧Alarm Relay current carry ability: 1A @ DC24V |
SNMP Trap |
‧1. Cold start, 2. Link up/down, 3. X-Ring topology changed
‧4. Authorization fail, 5. PD disconnect trap-PoE port event |
DHCP |
‧Provide DHCP Client/ DHCP Server/ Port and IP Binding |
DNS |
‧Provide DNS client feature and support Primary and Secondary DNS server |
SNTP |
‧Support SNTP to synchronize system clock in Internet |
Firmware Update |
‧Support TFTP firmware update, TFTP backup and restore |
Configuration upload and download |
‧Support binary format configuration file for system quick installation |
ifAlias |
‧Each port allows importing 128bit of alphabetic string of word on SNMP and CLI interface |
Case |
‧IP-30 |
Installation |
‧Provide DIN rail kit and wall mount ear for wall mount or DIN-type cabinet install |
PoE Power Budget |
‧142Watts Max. @ 48VDC (Full loading with PoE) |
Power Supply |
‧External Power Supply: DC 48V, Redundant power DC 48V and connective removable terminal block for master and slave power |
Environment |
‧Wide Operating Temperature: -40℃~75℃
‧Operating Humidity: 5% to 95% (Non-Condensing) |
Dimension |
‧72 * 105 * 152 mm |
EMI |
‧FCC Class A, CE EN61000-4-2, CE EN61000-4-3, CE EN-61000-4-4, CE EN61000-4-5, CE EN61000-4-6, CE EN61000-4-8, CE EN61000-4-11, CE EN61000-4-12,
CE EN61000-6-2, CE EN61000-6-4 |
Safety |
‧UL, cUL, CE/EN60950-1 |
Stability Testing |
‧IEC60068-2-32 (Free fall), IEC60068-2-27 (Shock), IEC60068-2-6 (Vibration) |